Faddom Help Center

Install/Define Sensors

When NetFlow capture is used, it is in most cases possible to use a single sensor that is installed on the same host as the Faddom Server.

  • If am Faddom Server VA has been deployed, then a sensor is already installed and defined on the server host.
  • If the Faddom Server has been installed on a Windows host, then install the sensor locally through the <Faddom Install Folder>\Sensors\Windows folder. Then define the sensor through Faddom Web GUI.

In case that additional sensors are required, please use the instructions in the Faddom Discover Installation Guide for installing the sensors, then define these sensors through Faddom Web GUI.

Note: Please allow 24 hours from the time a sensor has been defined, before checking discovery results. The first 24 hours of traffic capture are required for getting reliable results.

Was this article helpful?
0 out of 0 found this helpful

Comments